RC2

RC2 is the electronic system for measuring engine speed and temperature. Featuring a magnetic case, meaning it can be attached to the bonnet or the side members to run the tests with extreme ease, RC2 features two modes for measuring engine speed: using a microphone and the residual battery capacity signal, or alternatively induction probes and piezo sensors. Both the emission analysis modules and the RC2 and RC3 modules are separate units from the MULTI PEGASO and can communicate with the latter without requiring connection cables. Nonetheless, when the test is complete they can be attached to the trolley with a quick and simple operation for maximum space-saving.

TECHNICAL SPECIFICATIONS

PROCESSOR SYSTEM
MB90F591 16MHz
EXTERNAL POWER SUPPLY
8 ÷ 32 Volt
WIRELESS CONNECTION
Bluetooth 1.2 technology
PETROL AND DIESEL DETECTION FROM BATTERY
Systems management at 12VDC and 24VDC
PETROL ANALOGUE DETECTION
Induction pincers

DIESEL ANALOGUE DETECTION
Piezoelectric pincers
ENVIRONMENTAL
Operating temperature: -5°C ÷ +40°C
Operating moisture: 10% ÷ 80% without condensate
Storage temperature: -20°C ÷ +60°C
DIMENSIONS
125x130x27 mm
WEIGHT
370 g.

RC3

TEXA’s revolutionary RC3 not only keeps engine RPM and temperature under constant control but also serves as an ECU scanning tool. It therefore allows mechanics to perform two types of test using just the one tool.
The RC3 (Revolution Counter 3) interface can read data in three different ways: using an induction clamp with piezoelectric sensors, using a microphone with the residual battery signal, or directly from the OBD socket (on vehicles with the necessary protocol).
When plugged into the OBD socket to measure engine RPM and temperature, RC3 reads data directly using EOBD protocol, so there is not even any need to open the bonnet.RC3 can also be used in scan-tool mode; connected to the EOBD socket, it can read the parameters defined by this standard in accordance with new emission control procedures.

TECHNICAL SPECIFICATIONS

PROCESSOR SYSTEM
MB90F591 16MHz
SERIAL RESOURCES
1 1.1 USB Connection
1 RS232 standard connection
EXTERNAL POWER SUPPLY
8 ÷ 32 Volt
WIRELESS CONNECTION
1.2 Bluetooth technology
PETROL AND DIESEL DETECTION FROM VEHICLE BATTERY
12VDC and 24VDC Systems management
PETROL ANALOGUE DETECTION
Amp clamp